but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Rut
Obi Wan
Offline
-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
TR4/4A Parts in boot
- Thread starter Rut
- Start date
Share this page
TexasKnucklehead
Jedi Knight
Offline
I'm fairly certain the wooden thing near the middle is known as a "ruler". -odd because it "rules" nothing and is not showing metric units. It could be used to calibrate the imperial speedometer. 
The shoulder bolt and locking nut look familiar, but I can't place it.
The shoulder bolt and locking nut look familiar, but I can't place it.
Geo Hahn
Yoda
Offline
'Ruler' because it was the same length as the ruler's (king's) foot. I just made that up I think.
The shoulder bolt & nut look like the hardware for an E-Type bonnet link but Brown's Lane was almost 3 miles from the Triumph factory.
The studs look like studs - one is long and one is short.
The shoulder bolt & nut look like the hardware for an E-Type bonnet link but Brown's Lane was almost 3 miles from the Triumph factory.
The studs look like studs - one is long and one is short.
M_Pied_Lourd
Darth Vader
Offline
The little triangular thing....is it possible that it might be off the top of a brake caliper?
Cheers
Tush
Cheers
Tush
TexasKnucklehead
Jedi Knight
Offline
I think the bolts are for a very specific purpose because of the machined shoulder just below the head. ?
The small shoulder bolt could be MOSS PN 582-735, the TR4A hand brake fulcrum pin, and the nut would go on it. It might be the same as the TR6 pin, and why I remembered it.
A foot long foot is a pretty long foot. It's bigger than a size 12. Maybe it is king sized.
The small shoulder bolt could be MOSS PN 582-735, the TR4A hand brake fulcrum pin, and the nut would go on it. It might be the same as the TR6 pin, and why I remembered it.
A foot long foot is a pretty long foot. It's bigger than a size 12. Maybe it is king sized.
Online
Boy, ain't we a helpful bunch!
Studs look like they're for attaching a head to a block. No idea what car, though. And the little shoulder bolt looks like it would be for a valve cover. But the brake fulcrum pin is a good guess, too.
Studs look like they're for attaching a head to a block. No idea what car, though. And the little shoulder bolt looks like it would be for a valve cover. But the brake fulcrum pin is a good guess, too.
