-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Panhard Rod on a TR3
- Thread starter karls59tr
- Start date
Share this page
AEW
Jedi Hopeful
Offline
Not really able to answer your question, but a thought...
https://www.rhoadescamaro.com/build/
This link is supposed to be to a page where the author discusses a Watt's link. What I get out of it is that it at least does what the old Panhard rod would do to stabalize the location of the third member, but from the back of the diff instead of trailing to it. Also it seem to force the travel of the diff to remain perpendicular to the line of the car preventing the arc swing from a leafspring mount point. I could visualize a version of this up in between the diff and the tub wall on my TR3. Maybe more so than a traditional panhard rod. I wonder if the TR3 has enough clearance below the frame to permit a trailing link, since the axle is lifting off the rail not dropping away.
Good luck with your research,
https://www.rhoadescamaro.com/build/
This link is supposed to be to a page where the author discusses a Watt's link. What I get out of it is that it at least does what the old Panhard rod would do to stabalize the location of the third member, but from the back of the diff instead of trailing to it. Also it seem to force the travel of the diff to remain perpendicular to the line of the car preventing the arc swing from a leafspring mount point. I could visualize a version of this up in between the diff and the tub wall on my TR3. Maybe more so than a traditional panhard rod. I wonder if the TR3 has enough clearance below the frame to permit a trailing link, since the axle is lifting off the rail not dropping away.
Good luck with your research,
billspohn
Jedi Knight
Offline
A Panhard mounts on the diff at one side and on the frame at the other. You have to get the right angle and mounting points to avoid problems.
A Watt's link is two rods both mounted to the frame and mounted at the other end to a bellcrank attached to the back of the differential. It is better than a Panhard as it defines motion for the diff in a strictly up and down direction, but they take more room and are a bit more fuss to mount and set up correctly.
A Watt's link is two rods both mounted to the frame and mounted at the other end to a bellcrank attached to the back of the differential. It is better than a Panhard as it defines motion for the diff in a strictly up and down direction, but they take more room and are a bit more fuss to mount and set up correctly.