Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
I was just checking out my new Moss catalogue and happen to notice that the overdrive in my BN1 has the solenoid bracket for the BN2 on it. So I presume that my BN1 was built close to the transition to the next version of overdrives . And would the overdrive be adjusted the same as the earlier version? Always wondered why mine didn't have a cover over the solenoid bracket!!!
-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
overdrive ID
- Thread starter rustynuts
- Start date
Share this page
Offline
BN1 cars had a cover. BN2, BN4, & BN6 did not. BN7 & up had a cover. They would all be adjusted the same way.
The BN1 OD had two horizontal read mounts. The BN2 OD had two angled rear mounts.
Does your car have the three speed or the four speed transmission? Two OD relays on the inside of the firewall or one relay on the engine side?
The transition from BN1 to BN2 was around car #228047, but there could be variations.
D
The BN1 OD had two horizontal read mounts. The BN2 OD had two angled rear mounts.
Does your car have the three speed or the four speed transmission? Two OD relays on the inside of the firewall or one relay on the engine side?
The transition from BN1 to BN2 was around car #228047, but there could be variations.
D