Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Jim B.
Member
Offline
I have posted this on another site. I see some members from that site here. To them, please accept the double posting. I note other members that have not seen this so it may be of some use or interest to them.
I grew up in the era of chrome. I like chrome. My TD has some, but there were some aftermarket accessories that add additional "Bling".
I have an engine turned SS dash. These were in the Moss Catalog of the time. I have a 1967 copy that shows them. Many prewar MG roadsters of the time had them from the factory.
I never really liked the fabric covered dash. I always considered it an economy item.
I also have matching engine turned SS door threshold plates.
And of course I have A Moto-Lite steering wheel
It was suggested that I needed to do something with the standard wheel center. Looking on the Net I found some interesting examples, however mine is mostly my design. I started with a 6" diameter block of Aluminum, and kept removing metal until it looked right. The MG center is a turned down wheel cover medallion. The center is a light press fit augmented by some locktite.
Of course I just had to have a matching shift knob.
Again the medallion is from a wheel cover. The ball is from McMaster-Carr.
Do you think I have enough Bling now?
I grew up in the era of chrome. I like chrome. My TD has some, but there were some aftermarket accessories that add additional "Bling".
I have an engine turned SS dash. These were in the Moss Catalog of the time. I have a 1967 copy that shows them. Many prewar MG roadsters of the time had them from the factory.
I never really liked the fabric covered dash. I always considered it an economy item.
I also have matching engine turned SS door threshold plates.
And of course I have A Moto-Lite steering wheel
It was suggested that I needed to do something with the standard wheel center. Looking on the Net I found some interesting examples, however mine is mostly my design. I started with a 6" diameter block of Aluminum, and kept removing metal until it looked right. The MG center is a turned down wheel cover medallion. The center is a light press fit augmented by some locktite.
Of course I just had to have a matching shift knob.
Again the medallion is from a wheel cover. The ball is from McMaster-Carr.
Do you think I have enough Bling now?
