Offline
When removing my 100 BN2 exhaust manifold I noticed oil seeping out around the number 4 bolt. It was the only one out of the 6 that had any oil leak. I guess there must be a pocket of oil in that area. Should I do anything to seal it or just tighten it down first before installing new exhaust manifold? I have heard that if these bolts are too tight they can maybe cut through into water or oil areas?? So do I just tighten it down or do I try to clean area so thread sealant might help.
I noticed this when replacing my old 100M carbs with a new pair of 100M carbs from Moss. My engine has not been running smooth so trying new carbs plus sent distributor out to Advance Distributor for rebuild 6 weeks ago. I just reached a point where I needed to start fresh. So any ideas on this oil seep problem before I put things back together? Thanks Marty
I noticed this when replacing my old 100M carbs with a new pair of 100M carbs from Moss. My engine has not been running smooth so trying new carbs plus sent distributor out to Advance Distributor for rebuild 6 weeks ago. I just reached a point where I needed to start fresh. So any ideas on this oil seep problem before I put things back together? Thanks Marty