Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
cpbol
Freshman Member
Offline
I have my BJ8 torn down and I’m in the process of replacing the rings. The bores and pistons measure in spec, so I just deglazed the bores and ordered a new set of std bore rings from Moss.
The new 3-piece oil rings from Grant piston Rings seem to be wrong. The stock rings are 3/16 thick and have a radial wall of about .130”. Groove depth is .160” from the face of the ring lands. The new rings measure.170” radial wall and stand proud of the groove.
I’m trying to figure out if they were just packed wrong or has anyone else had this issue? It isn’t easy finding oil rings in this thickness and bore size 3.281. 83.5mm is slightly more common but I can’t find those in 3/16” thick online.
Thoughts?
The new 3-piece oil rings from Grant piston Rings seem to be wrong. The stock rings are 3/16 thick and have a radial wall of about .130”. Groove depth is .160” from the face of the ring lands. The new rings measure.170” radial wall and stand proud of the groove.
I’m trying to figure out if they were just packed wrong or has anyone else had this issue? It isn’t easy finding oil rings in this thickness and bore size 3.281. 83.5mm is slightly more common but I can’t find those in 3/16” thick online.
Thoughts?
