Offline
This doesn’t seem right. The slot on the bottom of the distributor shaft only engages the oil pump blade by 3 mm. New oil pump. Distributor never installed since engine rebuild. The oil pump blade is about 8 mm tall.
Have not been able to engage it at all, actually, because I can’t seem to line things up. But, first things first... why is the pump barely engaging and potential causes/solutions? Can I move that shaft further down?
Have not been able to engage it at all, actually, because I can’t seem to line things up. But, first things first... why is the pump barely engaging and potential causes/solutions? Can I move that shaft further down?