-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Oil Pressure Valve
- Thread starter budk1953
- Start date
Share this page
aeronca65t
Great Pumpkin
Offline
Not sure what device you're talking about.
Do you mean the oil pressure relief valve?....or the oil pressure sending unit?
Do you mean the oil pressure relief valve?....or the oil pressure sending unit?
dklawson
Yoda
Offline
On the A-series engines the relief valve is indeed the valve with the domed nut and the long spring underneath.
On transverse engine A-series cars it's common to replace the standard plunger/spring valve assembly with a ball bearing, shortened spring, and adjusting knob (modified) dome nut. So much debris gets in the oil system of the transverse engines that using the ball minimizes problems with the relief valve and the adjusting knob lets you dial in your oil pressure.
I wouldn't think it necessary on an inline engine. Still... it's a fun little change.
On transverse engine A-series cars it's common to replace the standard plunger/spring valve assembly with a ball bearing, shortened spring, and adjusting knob (modified) dome nut. So much debris gets in the oil system of the transverse engines that using the ball minimizes problems with the relief valve and the adjusting knob lets you dial in your oil pressure.
I wouldn't think it necessary on an inline engine. Still... it's a fun little change.
would it be a good idea to replace the oil pressure valve assembly?
Certainly wud B a good idea to examine the bullet taper for abnormal wear and the spring for good tension. Unless you have a new spring for comparison that would B a hard task tho. Unless current stoks from the usual suspects are NOS the afteramrket pieces will be highly suspect.
Very easy to modify the holder/cap for adjustability of the spring if necessary.
Certainly wud B a good idea to examine the bullet taper for abnormal wear and the spring for good tension. Unless you have a new spring for comparison that would B a hard task tho. Unless current stoks from the usual suspects are NOS the afteramrket pieces will be highly suspect.
Very easy to modify the holder/cap for adjustability of the spring if necessary.
