TR6 obscure tr250 tr6 seat rail question

[glemon]

The seat slider mechanism, is there something that goes on the back top of the mechanism like a couple metal plates or something that the seat retainer catches (keep it from flipping forward) and also maybe makes the seatback rake a little less severe, I though I pulled a couple of plates off, but of course I cant find them, I don't see anything listed in my factory tr250 parts book, but there is a threaded bolt hole to fig something there, am I nuts? maybe I should rephrase that, am I misremembering about this part?

 

[Gliderman8]

There is a plate at the end of the seat rail where the spring latch fits into to hold the seat in the down position.
See diagram below...

 

[Tr4dude]

here is a pic of them.

 

[glemon]

Thanks, now since you are answering my questions so well can you tell me where I put them so they wouldn't get lost during the restoration? Just kidding, I must heve either not had them or they were mistaken for scrap and discarded, or perhaps the most likely scenario, they will turn up after I spend a couple hours meticulously crafting near perfect replicas.

Greg

 

[Lewis_McDorman]

Thanks, now since you are answering my questions so well can you tell me where I put them

Yes, they'll be in the last place you look.