• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

TR2/3/3A O/D brass cap leaking

Share this page

M

mallard

Luke Skywalker
Country flag
Offline
After changing the fluid in the trans and O/D the large brass drain at the filter is leaking. I did reuse the fiber washer that was new before the change. I'm going to get a new washer, but has anybody any ideas how to keep this from leaking. Before the change it did leak but only a drop once in awhile. I was thinking of Teflon tape on the threads and trim off any extra.
 
I replaced it with a new fiber washer from Rimmer Bros. abut a month ago. Still leaks.
 
I scrapped the fiber washer...that always leaked and locked the nut in place...and now use an o-ring from Ace Hardware. Works great and I don't have to crank the nut down super tight any more.
 
CJD said:
I scrapped the fiber washer...that always leaked and locked the nut in place...and now use an o-ring from Ace Hardware. Works great and I don't have to crank the nut down super tight any more.
Click to expand...


I followed John's suggestion a month or two ago.. No more leak.......(from there anyway!)

from my previous blog entry, fwiw:
"I went with John's suggestion of an O-ring for the OD plug. (Used the 2- 3/16" narrower ring, pictured above & only snug tight , like a spin on oil filter.)"
 
mallard said:
After changing the fluid in the trans and O/D the large brass drain at the filter is leaking. I did reuse the fiber washer that was new before the change. I'm going to get a new washer, but has anybody any ideas how to keep this from leaking. Before the change it did leak but only a drop once in awhile. I was thinking of Teflon tape on the threads and trim off any extra.
Click to expand...

Im a big fan of Teflon tape but this is not the place.
I had the same issue and made a new washer from some .090 velum gasket material.Mine also needed some cleaning
up a with a file on the sealing surface of the nut where it was nicked from probably an adjustable or improper wrench.
Tom
 
Thanks guys for the ideas.
 
Back
Top