Hi Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
HAN8L1965
Jedi Warrior
Offline
Help needed. I am not getting a spark, was getting a weak spark found out my new condenser was shot, put in a new one and arranged the wiring. Please see picture, a little blury but I set it up according to the VB diagrahm.
I attached the terminal lead under the point spring, then a plastic washer, then the point spring, the condenser lead followed by a nother plastic washer then the set nut. The plastic washers have an extension that fits down into the spring on both the bottom and top plastic washer, I have let the flat side up. Or is this all wrong? I am using a new coil.
I attached the terminal lead under the point spring, then a plastic washer, then the point spring, the condenser lead followed by a nother plastic washer then the set nut. The plastic washers have an extension that fits down into the spring on both the bottom and top plastic washer, I have let the flat side up. Or is this all wrong? I am using a new coil.
