Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
duplaga1952
Member
Offline
I have a 1968 Sprite. When I purchased it, the wiring harness was clipped off 1 foot beyond the firewall.
New wiring harness - as the harness goes to the headlights it branches off: at the end of the branch is the big brown wire with the yellow stripe, and little brown wire with a green stripe to the generator. Back up the branch is a single white wire with a black stripe. Four more inches up the branch are two wires - one white, and one white with a black stripe. Then comes the black wire with white stripe to the brake failure pressure switch.
My question is: the three wires between the generator and the brake failure wires - where do they go? Any help would be greatly appreciated - then the harness will be complete.
Thanks - Bob
New wiring harness - as the harness goes to the headlights it branches off: at the end of the branch is the big brown wire with the yellow stripe, and little brown wire with a green stripe to the generator. Back up the branch is a single white wire with a black stripe. Four more inches up the branch are two wires - one white, and one white with a black stripe. Then comes the black wire with white stripe to the brake failure pressure switch.
My question is: the three wires between the generator and the brake failure wires - where do they go? Any help would be greatly appreciated - then the harness will be complete.
Thanks - Bob