Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
I am installing a new wiring harness in my BN2, and I was wondering if there was any tech info out there on how to install. I have it all in except for a couple of items under the dash, wiper motor, overdrive, etc. Can any one help me? The wires I have left dont seem to match what is on the wiring diagram.
-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
New Wire Harness problems
- Thread starter ssprinkel
- Start date
Share this page
Offline
Hi & welcome to the forum,
Your question is kind of general.
I might be able to help you more directly, since we are both located in ID.
I have a BN2 with original wiring. Send me an email -
rusd@velocitus.net
D
Your question is kind of general.
I might be able to help you more directly, since we are both located in ID.
I have a BN2 with original wiring. Send me an email -
rusd@velocitus.net
D
Skip & Lynne
Jedi Warrior
Offline
I took my green shop manual to a blueprint shop and enlarged the wiring diagram page to a 36 inch by 36 inch sheet. I could read that thing from 20 ft. It made installing my harness about a 2 hour and 2 Coors light job and everything works.