• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

MGB New Dual SU's and Run-On

Share this page

B

BILLinPA

Freshman Member
Offline
1978 MGB

I posted this last night, but not sure what happened to it...anyway...

I have new dual SU's and the correct manifold, but my ARO is not connected.
I do have some kind of nut where I believe it should go, but not the connector.

My question(s): could this be causing my run-on?
Do I need it with SU's?
if so, what connector should I pick up?

BILLinPA.
 
Which version SU's? Is your timing set correctly? is the distributor a 25D or the one that came with a '78 18GV engine?

With SU's you ~shouldn't~ need it. BUT(!) a lot depends on some other factors.
 
Did it do this before the carb change? A wise man on this forum says "It's always the last thing you touched." It is detonation of fuel without spark (dieseling). Things said to contribute are octane level, combustion chamber pressure (excess carbon), combustion chamber temperature, plug tip temperature, mixture, idle rpm. Old chevvies with 230/250 6 cyls were bad for it, but stopped quickly when you blipped the throttle after shutdown (mixture).
Bob
 
Back
Top