• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Need Information on plug/screw size

Share this page

Bruce_B

Bruce_B

Jedi Warrior
Offline
This is a plug that screws into a inlet that's on the cylinder head just below and back of the thermostat housing, before the #1 cylinder. Anyone know what size it is? I've tried 1/4 and 1/2 pipe size. It's no. 48 on the moss motors picture, 1275 engine external.

thanks
 
I could not find #48 on the Moss web site for the 1275 engine externals. You aren't talking about the bypass hose nipple are you?

You said that you tried 1/4 and 1/2 NPT taps. If it was between those sizes, the hole is likely threaded 5/8-18. BMC used that on places like the banjo bolt hole on the block and the temperature sending unit on the head.
 
It is 5/8”-18 (or 5/8's NF). In the head, the adapter has male 5/8” NF threads (uses a copper crush ring to seal) that threads into the head and 5/8” NF female for the capillary tube and nut.
Bruce, are you missing yours?
"Dug"
 
I am missing it. I'll take this info and try to pick one up at the hardware store.

Thanks for the info. Great source of info. on this forum as always.
 
Back
Top