• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

NATC 2011 Breckenridge Colorado

Share this page

Were you trying to put a TR6 Trans into your GT6? The TR6 trans is actually pretty stout. The GT6 on the other hand, a little on the weak side for even a stock engine, especially if it had a hard life.
 
The car had the TR6 motor in when i bought it, probably put in before i was even born. Atleast a GT6 motor works in a GT6 and it doesn't wear out the pressure plate on it's own.
 
Considering the primary difference between the two engines is 3/4 of an inch more stroke on the TR6 engine, any inherent weakness in one would tend to be present in the other.

Is the trans actually a TR6 trans? The GT6 trans will bolt right up to a TR6 engine. At most the rear engine plate would need to be re-drilled but that would be it. I've seen it done with little more than that anyway.
 
Yep the tranny is from a TR6. I do have a spare GT6 tranny laying around i might throw on it, but thats if i also have a GT6 drive shaft. I do believe the tr6 drive shaft is shorter.
 
Back
Top