• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

My Engine Bits ARRIVED

Share this page

abarth69

abarth69

Jedi Warrior
Country flag
Offline
I sat down Sunday night on the computer and ordered all the parts needed for my 1275 engine rebuild. Used Hap's list from Ray's engine build as a guide. Well today about 99% arrived at my door.

Just not sure about going with Alu fly wheel and the extra cost?

Need some input on the subject

Cheers

Boy going to have this back on the road faster then my Abarth.

Mark
 
if you need a place to keep that engine once it is rebuilt I just might have an engine bay
 
For reference, the build that Hap just did on my motor (https://www.drooartz.com/index.php?page=44) is very similar to Ray's, but without a few of the more exotic bits (I kept the stock rockers and the stock flywheel for instance, but most of the internal bits are the same). It's a street motor, so for me I didn't see the cost/benefit of switching out the flywheel. Your mileage may vary, as always. :smile:
 
Thats it Drew

I think I will stay away from the fly wheel after all it's the wifes car.

Would not want her to out run some of my cars

Cheers

Mark
 
Back
Top