Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
CanberraBJ8
Jedi Trainee
Offline
Not a lot achieved yesterday - got a cold, which had dented my effectiveness..:sorrow:
However, I picked up the muffler which has had the tail pipe cut off and a section of it rejoined to provide the bend for the side exit. I got a coat of silver heat paint, and looks good - I only meant it to be an interim solution while I find a more appropriate muffler (a little...lot... bigger so as for long distance driving comfort), but suspect it'll be fun for a bit, or until the Law gives me a ticket for noise pollution
Also i fitted one of the seat belt brackets and the rest of the belt. It still needs a couple of washers here and there to either provide a metal to metal mount (as there is Dynamat caught between the bracket and the floor etc), and the radius arm needs a slightly longer bolt so I can fit a Nyloc nut or a split washer. Looks like it will work fine though. I'll get a better photo this these when I can get the car out into the light - the garage is very dark atm.
However, I picked up the muffler which has had the tail pipe cut off and a section of it rejoined to provide the bend for the side exit. I got a coat of silver heat paint, and looks good - I only meant it to be an interim solution while I find a more appropriate muffler (a little...lot... bigger so as for long distance driving comfort), but suspect it'll be fun for a bit, or until the Law gives me a ticket for noise pollution
Also i fitted one of the seat belt brackets and the rest of the belt. It still needs a couple of washers here and there to either provide a metal to metal mount (as there is Dynamat caught between the bracket and the floor etc), and the radius arm needs a slightly longer bolt so I can fit a Nyloc nut or a split washer. Looks like it will work fine though. I'll get a better photo this these when I can get the car out into the light - the garage is very dark atm.