• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

MOWOG oil pump cover- attachment to back plate?

Share this page

chrpark

chrpark

Senior Member
Offline
on the 948cc motors, what holds the round MOWOG oil pump cover to the backplate? Does it go under the bakplate, between the backplate and the block? Or some sort of gasket adhesive just attached to the backplate itself?
THANKS
 
It goes between the block and the backplate, usually soldered to the backplate but not always.
The block to backplate gasket seals it up.
BillM
 
Excuse please. On a 948 the cover goes on the outside back of the backplate and is held on with solder or in my case brazeing. Solder from the factory.
 
Aha! Didnt think it would fit behind backplate without creating a gap. Now have to figure out the solder or brazeing

thx
 
Brazing is easy, take it to your friendly welding shop. I have seen sodder crack/melt from time to time and destroy an engine. Folks were not watching temp and oil pressure I guess.

Brazing is for ever.
 
I will agree with Jack since it has been a lot of years since I played with a 948 (I thought that they were the same as the 1275) and any radiator shop should be able to solder the can on.
Bill
 
Good point on radiator shop, did not think of that.
 
Back
Top