-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
moss rear crank oil seal
- Thread starter rjc157
- Start date
Share this page
John_Progess
Jedi Warrior
Offline
rjc,
I installed one on my BJ8 and I believe that I used 10-32 screws rather than the metric supplied with the seal. I cannot remember the number drill you use for 10-32 screws but it is readily available. The seal is working fine and was not that difficult to install. Have a good day!
John
I installed one on my BJ8 and I believe that I used 10-32 screws rather than the metric supplied with the seal. I cannot remember the number drill you use for 10-32 screws but it is readily available. The seal is working fine and was not that difficult to install. Have a good day!
John
Robert560
Senior Member
Offline
I also used the Moss kit, and had no issues. I found a 4.2mm drill bit through Amazon. I put a little of the work on my website... might find something useful there...
https://www.astraldimensions.com/healey/rearseal.html
~Bob
https://www.astraldimensions.com/healey/rearseal.html
~Bob
Johnny
Luke Skywalker
Offline
I put on my BJ7 when I rebuilt the transmission. You don't have to remove the backing plate but beleive me it's a lot easier. You have to cut or grind a section of the backing plate for it to fit properly. The drilling and tapping wasn't that difficult. A member of our car club had the drill and tap required. If you belong to a club I'd ask around.