-
Hi Guest!
You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
moss rear crank oil seal
- Thread starter rjc157
- Start date
Share this page
John_Progess
Jedi Warrior
Offline
rjc,
I installed one on my BJ8 and I believe that I used 10-32 screws rather than the metric supplied with the seal. I cannot remember the number drill you use for 10-32 screws but it is readily available. The seal is working fine and was not that difficult to install. Have a good day!
John
I installed one on my BJ8 and I believe that I used 10-32 screws rather than the metric supplied with the seal. I cannot remember the number drill you use for 10-32 screws but it is readily available. The seal is working fine and was not that difficult to install. Have a good day!
John
Robert560
Senior Member
Offline
I also used the Moss kit, and had no issues. I found a 4.2mm drill bit through Amazon. I put a little of the work on my website... might find something useful there...
https://www.astraldimensions.com/healey/rearseal.html
~Bob
https://www.astraldimensions.com/healey/rearseal.html
~Bob
Johnny
Darth Vader
Offline
I put on my BJ7 when I rebuilt the transmission. You don't have to remove the backing plate but beleive me it's a lot easier. You have to cut or grind a section of the backing plate for it to fit properly. The drilling and tapping wasn't that difficult. A member of our car club had the drill and tap required. If you belong to a club I'd ask around.