• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

Mixing one and two post fulcrum brackets

Share this page

T

tdskip

Yoda
Offline
Any problem in mixing the three original one post a-arm fulcrum brackets and one two-post replacement one? The other original one post stud is bent, hence the question.

Thanks!
 
Tom,

So you are looking to only replace the one bad one and not do the whole strengthening for the front suspension(2-post brackets and reinforcing plates for all of them)?

I don't see where it would hurt just doing the one.

Scott
 
Hi Scott. I did weld the additonal gussets on, I'm just not sure if the geometety of the later two post bracket is different than the one post.

Thanks!
 
Back
Top