Mgtd wouldn’t go forward or

[lumpy]

Mgtd wouldn’t go forward or reverse when put in gear. I was driving and stopped and heard a loud clang when I started to drive away it wouldn’t move.
Got the car jacked up and the driveshaft turns when put in forward and reverse but not fast. How can I check what went wrong.
Could an axle broke or something else happen.
Like in Bluffton SC and no repair shops want to even look at it.
Any suggestions for repairs or persons I can bring it to.
Thanks John

 

[bobhustead]

Post this in MG, not New Member Intro and you will get more eyes.
Bob

 

[JPSmit]

No personal experience but it sounds a lot like a half shaft. Probably not a super difficult DIY project but, as per Bob's suggestion, the MG forum would have more expertise.

 

[lumpy]

No personal experience but it sounds a lot like a half shaft. Probably not a super difficult DIY project but, as per Bob's suggestion, the MG forum would have more expertise.

Thanks, I will check it.

 

[lumpy]

Thanks, I will check it.

I have checked the forum and you to but don’t really see anything. I’m new to the new forum so I could of did something wrong . But thanks again for your response.

 

[JPSmit]

take a look at the other request - I posted some videos

 

[lumpy]

take a look at the other request - I posted some videos

I wished it was for a TD. I think the TD replacement is much different from what I been looking at. Thanks for your response.

 

[JPSmit]

good luck!