• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

MGB MGB starter and a TR6

Share this page

TR6oldtimer

TR6oldtimer

Darth Vader
Offline
Question, is the spire nut used on the rear of the starter armature on a MGB the same as used on some TR6 starters, specifically the 2M100 Lucas starter. The armature end shaft is 7/16 inch in diameter?

Thanks
 
Hey guys, there must be someone here who has this type of starter on, or from a B.


MGB-081.gif


The part I am looking for is the spire nut (contained in the bag marked 52). The kit is no longer available, but the spire nut is. Now I know the part is only $3.50, but by the time I add other parts (which I don't really need) to meet the minimum, then add shipping, and I am up to $40. Not a lot of money I know, but I just do not want to hear from the other half if the nut does not fit. :eeek: Been there, done that.

Any help would be greatly appreciated.
 
Back
Top