• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

MGB MGB Banjo Rear Hub re and re wire wheels

Share this page

M

MDrex

Freshman Member
Offline
I have run into a problem. I am reinstalling the rear hubs on 64B (wires) after renewing brearings and seals. I pressed the bearings in until seated, which had them recessed from the hub face. I then pressed the hubs onto the axles until seated. Seating the hubs, pushed the bearings back out, and the bearings are no longer seated, but flush with the face of the hub. Which should be seated, the bearings or the hubs, or did I screw something up. Checked Bentley, Clymer, MG with Attitude, MG experience, but cannot find answer.

Thanks, Mark
 
Back
Top