• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

MGB MGB Banjo Rear Hub re and re wire wheels

Share this page

M

MDrex

Freshman Member
Offline
I have run into a problem. I am reinstalling the rear hubs on 64B (wires) after renewing brearings and seals. I pressed the bearings in until seated, which had them recessed from the hub face. I then pressed the hubs onto the axles until seated. Seating the hubs, pushed the bearings back out, and the bearings are no longer seated, but flush with the face of the hub. Which should be seated, the bearings or the hubs, or did I screw something up. Checked Bentley, Clymer, MG with Attitude, MG experience, but cannot find answer.

Thanks, Mark
 
Back
Top