-
Hi Guest!
If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
MGA MGA Seat Question - frame bolt assembly pictures
- Thread starter tdskip
- Start date
Share this page
John_Progess
Jedi Warrior
Offline
Tdskip,
I have a picture of my Coupe seats. I cannot remember how to send a picture in a reply but if you will send me an email I will get the picture to you. (johnprogess@comcast.net (not progRess)). Have a good day!
John
I have a picture of my Coupe seats. I cannot remember how to send a picture in a reply but if you will send me an email I will get the picture to you. (johnprogess@comcast.net (not progRess)). Have a good day!
John
John_Progess
Jedi Warrior
Offline
Tdskip,
The attachment bolt is a 1" long 5/16" diameter bolt. Click on the attachment for a picture. The picture is of the driverside outside attachment. The seat back portion of the attachment is threaded for 5/16" fine threads so the bolt must go in from the inside. There is a washer between the seat back frame and bottom frame portion. Then there is a nut on the outside that acts as a jam nut. Hope this helps and have a good day!
John
The attachment bolt is a 1" long 5/16" diameter bolt. Click on the attachment for a picture. The picture is of the driverside outside attachment. The seat back portion of the attachment is threaded for 5/16" fine threads so the bolt must go in from the inside. There is a washer between the seat back frame and bottom frame portion. Then there is a nut on the outside that acts as a jam nut. Hope this helps and have a good day!
John