• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Master Cylinders

Share this page

S

shorn

Jedi Knight
Country flag
Offline
Since I have emptied out my BJ8's engine compartment for painting as the engine is being rebuilt, I thought this would be a good time to rebuild the clutch and brake MCs. Is there a correct procedure for separtating the spring assembly? The bores don't look pitted so I think they are rebuildable.
 
Hi Shorn, You really do not have to separate the valve assembly since the rubbers go on opposite ends.However, there is a valve clip located at the valve rod that acts like a circlip and releases the two sections.--Fwiw--Keoke
 
Back
Top