• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Master Cylinders

Share this page

S

shorn

Jedi Knight
Country flag
Offline
Since I have emptied out my BJ8's engine compartment for painting as the engine is being rebuilt, I thought this would be a good time to rebuild the clutch and brake MCs. Is there a correct procedure for separtating the spring assembly? The bores don't look pitted so I think they are rebuildable.
 
Hi Shorn, You really do not have to separate the valve assembly since the rubbers go on opposite ends.However, there is a valve clip located at the valve rod that acts like a circlip and releases the two sections.--Fwiw--Keoke
 
Back
Top