• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)

GT6 Lucas Distributor cap on Delco D204 Dizzy GT6+

Share this page

19_again

19_again

Jedi Warrior
Offline
After reading about Jeff's new rotors, and thinking OH Boy another new thing to buy, I got curious. I have the above described cap and dizzy body on the GT6. anything special about this?
 
That's a good question . . .

Here's a link to Paul Tegler's website with a very good compilation of Lucas and Delco-Remy distributor specs:
https://www.teglerizer.com/mgstuff/advance_curves.htm

Also note here at the bottom of the page that the "Lucas Tuning Manual" may be downloaded in .pdf format. This is a very useful resource.

However, Tegler does not address if the caps are interchangable. Darned if I know. I'd tend to use the correct cap myself, they're not expensive.

Anyone else??? Andrew . . .?
 
vagt6 said:
...Tegler does not address if the caps are interchangable. Darned if I know. I'd tend to use the correct cap myself, they're not expensive.

Anyone else??? Andrew . . .?
Click to expand...
If you mean interchangeable between Lucas and Delco distributors, then no, they aren't.

"19 again": are you saying you have a Lucas distributor on your GT6? Nothing wrong with that, but I'll wager it's from a TR6 (or possibly a Vitesse, although that's rather unlikely for a US car). The GT6, as implicated on Paul Tegler's page, always used the Delco distributor.
 
No Andrew, I have a Lucas Distributor cap on a Delco-Remy distributor body. The body is marked Delco-Remy D204 7953547.
 
OK. I'm sure that Lucas either produced or at least repackaged caps to fit the Delco distributors. That's not uncommon; I used to buy (repackaged by? manufactured by?) Bosch caps, rotors, condensors and points sets for my Delco-equipped GT6+ back in the mid-1970s, as they then tended to be about the best quality replacement parts I could find. That was especially true of the points sets, which were assembled well and were "ventilated" to keep them from burning up so quickly.
 
19 again, I suggest to call Nigel at "SpitBits". He'll probably have the correct cap on-hand. You can have it at your door in no time flat.

Let us know, good luck!
 
Not certain, but I believe Lucas did make caps to fit the Delco distributors. They did make a lot of service parts to fit other company's products. However, as Andy says, I don't believe the caps or rotors will interchange between Lucas and Delco.

But check with Jeff to be sure, he may have a rotor available that will fit.
 
Back
Top