• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Lower Radiator Hose Connection

Share this page

Dave Richards

Dave Richards

Jedi Knight
Country flag
Offline
Is there an easy way to get to the lower clamp on a BJ8?
 
If it's anything like my BN2, nearly impossible from the top. Still difficult from the bottom with a ratcheting right angle screw driver. If you get it lose, turn it to a position which "might" be easier to get to next time.
D
 
Thanks Dave! Not good news, but I'll pick up a ratcheting screwdriver.
 
I do them from the top with a long screwdriver (drier that way too).

Undo the four (4) bolts into the bottom of the radiator (not the through bolts into the chassis) and just loosen the two (2) bolts at the top to swing the bottom out enough to access the clamp.

Taking it apart always depends how the last guy put it together, but that's the way I do them.
 
If you are not worried about originality and can get yours off, you can replace the lower hose clamp with one that has a hex head on it. I use an impact wrench with VERY low air pressure to be sure I do not over-tighten it. The impact wrench makes the job real simple since I do not have to have any clearance fto rotate the socket.
 
Yups!, sometimes you have to wonder how the previous installer of the clamp achieved such! (Was the name jesus, so as to manage such a miracle?) :smile:
 
Hi Dave,
Maybe it's just like real-estate. Location location location.

The clamp I use on mine has a hex nut with a flat head screwdriver slot. I positioned bolt head facing down at an angle towards the radiator release valve. I now have an easy access point with a screwdriver, or a 1/4" diameter socket extention shaft and socket. It's a straight shot.

Happy motoring!
Roger
 
Thanks Roger, you can bet that's how it's going back on!
 
Back
Top