• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

Looking for a screw?

Share this page

jlaird

jlaird

Great Pumpkin
Country flag
Offline
This one has a philips round head I beleive and larger than normal threads. It holds the lower half of the stearing shaft mount to the upper half where it is attached to the fire wall. I can not seem to find anything to fit. So if you have a parts car you will have two and hopefully Miss Agatha will have two as well. Only one now.
 
That screw is a 1/4 x 20 (not sure how long) but an inch or so and is available anywhere. 1/4 x 20 hex head will work too.
You probably have an old can of screws with a bunch of 1/4 20s in it.
 
Really, will look again. Oh is about an inch long.
 
i have the same bolt on my support. i can check it as well, but as i remember, it was a standard type thread and size.
 
I found one in an old box of stuff, had looked yesterday and did not see it. Old eyes. All's well, stearing installed.
 
Back
Top