• Hi Guest!
    If you appreciate British Car Forum and our 25 years of supporting British car enthusiasts with technical and anicdotal information, collected from our thousands of great members, please support us with a low-cost subscription. You can become a supporting member for less than the dues of most car clubs.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

longbridge bn4 100/6 tonneau bar brackets

Share this page

N

neilert

Senior Member
Offline
Does anyone have photos and dimensions of the tonneau cover support bar brackets for a longbridge bn4 100/6? I need the width, height, and angle of bend to fabricate a set.
 
Hi neilert,

Do you mean the small spigots that bolt to the rear wheel arches and fit inside the tonneau bar?

If so, I don't have photos, but simply made some up when I rebuilt my car. They were made from tube which fitted snugly inside the tonneau tube and was then flattened and bent to suit the rear wheel arch contours at the other end. They fit into the bar by about an inch and are totally about 2 inches long.

My car is away at the moment, but can take some photos when it returns if you require?

Cheers,

Mac.
 
No problem - finding Longbridge parts is like searching for the holy grail....

Larry
 
Back
Top