-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
long weekend things to do, whats ur list?
- Thread starter Woodie
- Start date
Share this page
Chris, I've always shimmed the distance piece and torqued to 45 lb/ft initially, then tighten further to line up the first available cotter pin hole. I think the distance piece adds rigidity to the spindle, although there are those who say it's not required with the tapered bearings. I would rather err on the side of caution. It's my butt in the seat, after all.
Jeff
Jeff
tony barnhill
Great Pumpkin - R.I.P
Offline
Well, I'm back home....
tony barnhill
Great Pumpkin - R.I.P
Offline
I was - but I've gotta get to work on the GRM car!