TR6 Lift Question

[novaman]

Is anyone using a BendPak HD9 to service or store their TR6? I'm just wondering whether the ramps on that model lift can be adjusted close enough to accommodate the track on a TR6. Based on my review of the specs it seems like it would be difficult. Thanks

 

[Geo Hahn]

At it narrowest the specs say it can be 37½" between the ramps. My lift (not Bend-Pak) is at 37" there and takes a TR4 with a bit more than an inch extra on each side.

https://www.bendpak.com/car-lifts/four-post-lifts/hd-9.aspx#

Apparently Bend-Pak also has a narrow version which is the same spacing as the HD9 at its narrowest, but non-adjustable.

https://www.bendpak.com/car-lifts/four-post-lifts/hd-9st.aspx

So 37½" should be fine -- you will need to be careful and consistent as you drive on but that is a time for paying attention to what you are doing in any case. Really pretty easy in a TR as you can lean left and see where the front tire is.

 

[3798j]

Here's a TR4A on a Direct Lift pp9 with 39" between ramps. Not difficult to drive onto.

 

[PeterK]

I have an Bend-Pak HD-7P, 37 1/2" between ramps and mine fits OK. I put a piece of masking tape on the driver's side to guide me to center. Most of the tires are on the ramps but there is a slight overhang to the inside. Had mine for many years now without a problem, great company (Bend-Pak) and a quality product IMO.

 

[mgedit]

Mine is not BendPak, but is 37.5 inches between ramps. The TR6 fits no problem at all, but the TR3 only has about half inch either side for clearance. I had an old mirror around the house and mounted it at an angle in front of the lift. I also painted the edges of the ramps white to make them easier to see. Now driving onto the lift even with the TR3 is an easy one person job. I can move the TR6 and take a "driving on" picture if it helps. Cheers, Mike