• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Learning a New Skill

Share this page

Hi Adrio,
That would be great if you found them! I'll send you a PM so that you remember who I am... it will probably be at least a month or two before I'm ready to tackle this. Need to finish up the welding on my tub and learn to sew, but think this will be a good winter project. thanks again

Jason
 
It is more I was thinking that Triumph had thousands of spare mk1 TR2 seat frames sitting around and used them in the mk1 spitfire. They look so close to the same.
 
Jason
I used Craig's pattern (pdf in the Wiki) for my TR3a seats. I would bet they could be altered to make a set for a 2. I could make some tracing from my cards. The arch is a simple 1/4 circle attached to a staight piece (the width of the top of the arch). I can make a tracing of that also.
Just pm me.
Paul
 
Back
Top