• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

key ID from a barrel?

Share this page

S

simon_mck

Freshman Member
Offline
HI,
I have a 1966 vehicle without door key or ignition Key.
I wondered if it was possible to find the key no somehow from the locks and ignite below?
Taken things apart with no damage.. bit the door lock, seems a pretty solid unit. The ignition barrel, isn't something ive take apart before.
Any ideas?? Cheers Simon


key02.jpg
key01.jpgkey03.jpg
 
There should be a number on the ignition key barrel. You can get a key made from that from Pete Groh. Search his name on this forum and you will find him. Alternatively, you get a key and replace the windows that work for the key divots. I could never find a key shop that would work on old British barrels, but they must be out there. I re-keyed my Austin Healey myself.

Jerry
 
Jerrry, many thanks for the reply. I wondered though, how can I access the barrel. The door lock is in a fairly solid box. The ignition barrel doesn't seem to want to pop out either.. Trying to figure without damaging :smile: ps this is for a rare Tippen Delta made in Coventry in 1966.
 
There is a hole in the side of the ignition unit and you put an awl or sharp object through that hole and press a spring, then the barrel should come out. I have to admit that usually, I have a key in the barrel to pull it out first. Since you don't have a key, that could be more problems. Since you are in England, I would think you could find a locksmith that would have experience with British cars.
 
Jerry said:
There is a hole in the side of the ignition unit and you put an awl or sharp object through that hole and press a spring, then the barrel should come out. I have to admit that usually, I have a key in the barrel to pull it out first. Since you don't have a key, that could be more problems. Since you are in England, I would think you could find a locksmith that would have experience with British cars.
Click to expand...

To operate the release pin, don't you have to rotate the cylinder all the way one way to clear the pin?
Depends on make and model, since all we know is "1966", here is a Sprite write-up:
"to fit, remove & disconnect ignition switch. Use the new barrel to locate a hole (approx 2-3mm dia) in the switch body. The hole will be a similar distance as the round brass spigot is(far right in photo) from the key face. Gently push a small screw driver (or similar) into the hole to push the spigot into the old barrel. Use the key to pull the old barrel out of the switch. Insert new barrel. Reconnect and replace switch."
[FONT=Arial, Helvetica, sans-serif][/FONT]
 
Back
Top