Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Electric door locks do not work. Have replaced the door lock module which is getting power. Even stuck in a different CPU. Gas cap lid unlocks sometimes. I need some ideas about how to diagnose the problem. The wiring diagram is pretty simple but I don't see what other component that could cause the problem.
-
Hi Guest!
You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
There are some perks with a member upgrade!**Upgrade Now**
(PS: Subscribers don't see this gawd-aweful banner
Jaguar XJ6 Door Locks
- Thread starter rupertle
- Start date
Share this page
D
Deleted member 8987
Guest
Guest
Offline
I seem to remember a Valet switch on some......
jessebogan
Jedi Knight
Offline
Assuming an XJ40, remember all the lock buttons have to be either UP or Down (synchronized) in order for it to work. Do you have the S57 wiring diagram? More info please
Michael J.
Jedi Warrior
Offline
Suggest removing each interior door panel and lubing the lock mechanism connections all through the linkage with WD-40 or Kroil. You can have enough friction from age adding up together to overcome the solenoid being able to move the linkages.
D
Deleted member 8987
Guest
Guest
Offline
Searching shows you are far from alone in this issue. However, the causes seem to be many.
Stiff mechanisms, as stated earlier, grounds and ground contacts inside door handles, one of two power supply sources to module, valet switch, etc.
Stiff mechanisms, as stated earlier, grounds and ground contacts inside door handles, one of two power supply sources to module, valet switch, etc.
Granted, one or more door lock mechanisms might be stiff--but would that cause all of the door locks not to work? Also one would expect to hear mechanisms trying to work if solenoids are getting power.
I believe there is someone out there who knows how to diagnose this problem. Where is that person?
I believe there is someone out there who knows how to diagnose this problem. Where is that person?