dcoplan
Member
Offline
Tried installing camshaft into my Bugeye today but it wouldn't go in because the pin at the end of the camshaft that engages with the oil pump is twisted making it too wide to seat properly. I spoke to a cam guy and he said that one side of the pin is smaller than the other (really hard to see that!) and to whack at it with a punch until it comes out, orient it correctly, and hammer it back in. I gave it a couple whacks and then stopped when it barely budged, fearing that I was going to screw up the camshaft and create bigger problems for myself.
Any advice??
Dan
Any advice??
Dan