-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Is there a cure for rubbing doors?
- Thread starter 198686d
- Start date
Share this page
john_j
Jedi Trainee
Offline
1) Is the door gap at the front correct/can you loosen the hinges and move the door forward slightly?
2) When you jack it up from the middle or one end does the gap change much. There will always be a small change, but if it's a big change you need some combination of new sills/floor/floor stiffeners (although a Frog door gap should get bigger at the top when the flor is rotten)
3) Otherwise, grind a bit off the edge of the door, weld it up again, spray it :eeek:
2) When you jack it up from the middle or one end does the gap change much. There will always be a small change, but if it's a big change you need some combination of new sills/floor/floor stiffeners (although a Frog door gap should get bigger at the top when the flor is rotten)
3) Otherwise, grind a bit off the edge of the door, weld it up again, spray it :eeek:
texas_bugeye
Jedi Knight
Offline
Is this at the hindge end of the door or the latch?
If its at the latch end it could be your hinges are getting worn. grab the door at the latch end and lift it if it moves up and down your hinges are worn.If this is the case you could try puting some tape around the edges of the door to protect them and loosen the top hinge in the door and lift it up a little and retighten it. Your going to need an extra set of hands to try this.
If its at the latch end it could be your hinges are getting worn. grab the door at the latch end and lift it if it moves up and down your hinges are worn.If this is the case you could try puting some tape around the edges of the door to protect them and loosen the top hinge in the door and lift it up a little and retighten it. Your going to need an extra set of hands to try this.
