• Hi Guest!
    You can help ensure that British Car Forum (BCF) continues to provide a great place to engage in the British car hobby! If you find BCF a beneficial community, please consider supporting our efforts with a subscription.
    There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Subscribers don't see this gawd-aweful banner
Tips
Tips

TR4/4A Installing wheel arch covers in a Tr4a

Share this page

T

Tr4aJim

Senior Member
Offline
Folks,

I am am putting a new interior in my Tr4a, and I'm not sure about the procedure for installing the wheel arch covers. I've read some posts on this forum, and others, but it's still not clear to me what steps to follow, especially regarding the glue application.

I've marked where the piping goes based on the old cover. So here come the questions.

Should the top and side pads be glued to the arch first, then glue the cover to the pad? Some info I've seen suggests gluing the pads to the covers, then gluing them to the arch as a single unit.

Should the the covers be glued to the top arch first, then pull & glue the arch side?

Should glue be sprayed over the entire arch surface (top, then side), or is glue only applied to the piping seam area, and just the edge of the top and side?

Any other tips?

thanks!

Jim
 
Back
Top