• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
  • When posting a classified ad, you MUST select a prefix from the drop-down next to the subject line. If you don't you will get an error and your ad will not be posted!
Tips
Tips

In-line fuse

Share this page

B

bugi

Member
Country flag
Offline
I am considering putting an in-line fuse in the wire from the battery to the ignition switch on my Bug Eye. Does anyone have any thoughts on the required amperage ?
 
If it goes then you are dead-in-the-water with no way to figure what went wrong.
It would probably be better to fuse the individual lines but 30 amps would probably be OK if you still want to do it.
BillM
 
30 amps will make the wire itself the fuse link, unless you mean a LUCAS 30 which is really about 17 amps. Most of the wiring is 14 gauge so nothing more than a Bussman (AGC) of 20 amps. ... but I agree with Bill M on this. Take his trouble shooting trick and put in a circuit breaker rather than a fuse. You'll be able to see if it popped, and it
can be easily reset.
 
Not much to add to the above. Fuse the circuits leaving the switch, not the wire going to it. Also, if you are going to add fuses, try not to add fuses inline with existing fuses. It can make troubleshooting challenging when you have to remember there is more than one fuse on a circuit.
 
Here's what I did on my Bugeye:

https://www.nonlintec.com/sprite/electrical/

You might want to take a look at the part about the design of fused branches. You don't need to do as much as I did, of course, but the principles still apply.
 
Back
Top