-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Spitfire ignition wire gauge
- Thread starter Darwin
- Start date
Share this page
dklawson
Yoda
Offline
The British specify their wire sizes differently than we do. The factory would have used something almost equivalent to 18 AWG. However, I would use 16 AWG just because it is readily available and a little heavier duty.
Incidentally, you can get all the original wire colors and sizes from the folks at BritishWiring.com.
Incidentally, you can get all the original wire colors and sizes from the folks at BritishWiring.com.
TR3driver
Great Pumpkin - R.I.P
Offline
From the diagram I'm looking at, that wire carries power for ignition, gauges, heater, turn signals, brake lights, wipers and reverse lights. Adding up some rough guesses for all those loads comes to almost 30 amps.
I believe original would have been 18 strand, which is roughly 14 AWG. Even using 12 AWG (or 44 strand) wouldn't hurt any.
I believe original would have been 18 strand, which is roughly 14 AWG. Even using 12 AWG (or 44 strand) wouldn't hurt any.