Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
SMGoose
Senior Member
Offline
For those of you who have been helping me these past few months (thank you, thank you, thank you!), you know all the trouble I've had getting this TR4 on the road. If you don't know, here's a brief rundown of the work I've done since buying it in November:
New exhaust The old one (oooollld one) was completely rusted, leaky, and poorly patched in places. Didn't even pass inspection.
New fuel tank and pump Old fuel tank was leaking. Replaced the old SU electric pump with a Facet electric.
Full tune-up Points, cap, rotor, condenser, plugs, wires, etc.
Replaced transmission, clutch, and release bearing Old transmission gave out during all the other work. Bearings broke loose and wreaked havoc on the mainshaft and other gears. Bought a rebuilt TR6 transmission from Foreign Car Enterprises in KC, MO. Went through the clutch system while I was at it.
Misc. Cleaned up carbs and replaced gaskets, replaced oil sump gasket.
I fully expected to have to do these things eventually, just not all at once and not so soon. So it's been a long winter! But thanks to all you folks on this forum, I've learned quite a bit along the way. So now it's time to show it off. The paint--in a few spots--and interior need some work, but, you know, baby steps. If any of you have any more suggestions, I'm all ears!
A walk-around:
And a short drive:
New exhaust The old one (oooollld one) was completely rusted, leaky, and poorly patched in places. Didn't even pass inspection.
New fuel tank and pump Old fuel tank was leaking. Replaced the old SU electric pump with a Facet electric.
Full tune-up Points, cap, rotor, condenser, plugs, wires, etc.
Replaced transmission, clutch, and release bearing Old transmission gave out during all the other work. Bearings broke loose and wreaked havoc on the mainshaft and other gears. Bought a rebuilt TR6 transmission from Foreign Car Enterprises in KC, MO. Went through the clutch system while I was at it.
Misc. Cleaned up carbs and replaced gaskets, replaced oil sump gasket.
I fully expected to have to do these things eventually, just not all at once and not so soon. So it's been a long winter! But thanks to all you folks on this forum, I've learned quite a bit along the way. So now it's time to show it off. The paint--in a few spots--and interior need some work, but, you know, baby steps. If any of you have any more suggestions, I'm all ears!
A walk-around:
