• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Hypothetical welder question

Share this page

Lets also include HeliArc (helium-arc welding) This is what TIG was when helium was the primary gas used.

If I had to only have one ... it'd be a MIG (because I'm impatient) :wink:
 
I have an AC/DC stick welder that I use for anything heavy or structural. I have access to a MIG but really only use it rarely, usually for plug welding. Like Tom, I keep coming back to my OA gear for anything that I can, especially sheet metal.
 
I've got a fair amount of welding equipment.

A proper spot welder for panels- it's the bee's knees and produces great welds that look original. But, if I wasn't doing extensive panel replacement it wouldn't be justified.

I got a mid-power MIG set up and used it a bit... but found that all the apatter was a major annoyance- my eyesight is poor and getting too close to the welding was not good.

I then got a oxy/ace gas and found that really useful, much easier to use. This is particularly good for non-welding heating tasks, like freeing rusted fasteners, burning out bushings that won't otherwise move, cutting metal, etc.

But what I like best for regular welding is a inverter (DC) TIG, it's smaller than the MIG and allows much more control over the welding; and there's no spatter at all so I can clearly see what the weld is doing.

If you can afford it I think the inverter TIG is better than the MIG; and that combined with a gas set-up would be ideal....
 
However, In my experience TIG uses more gas and the gas is more expensive.

But, I agree that it does afford MUCH more control than MIG ... but it is soooo slow (see a theme here?) :wink:
 
I forgot to mention that I also have the same Lincoln 110V MIG welder that Hap mentioned, but I keep it at work. It works fine for welding steel tube and stuff like 1/8" mild steel. It'll probably do more than that, but that's all we've used it for (building robots and go-karts). I use CO2/mix gas with it.

When "inverter" was mentioned, I was thinking the small DC arc welders that are available like THIS ONE

I've always called these "inverters".
I used one of these on our 24 Hours of Lemons car and it was quite good (and it was running off a generator). Nice, solid arc and good weld penetration. Not a TIG welder and does not use gas......just open stick.

I do like my oxy-acetelene tanks and my 220V Hobart Handler 187 MIG welder. It's nice to have both at home.
 
Back
Top