• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

HS4 plumbing

Share this page

Gundy

Gundy

Luke Skywalker
Offline
I finished off the HS4s setup with some Petroflex
hoses and nifty German clamps.
I'm thinking about using this type of clamp
for the radiator hose as well. Then paint the
little blue parts in AH green.
 

Attachments

  • 22244.jpg
    22244.jpg
    35 KB · Views: 229
  • 22245.jpg
    22245.jpg
    28.7 KB · Views: 229
Nice looking indeedie.
 
Very nice...useful bling. I need to get those steel braided hoses. Is that an aluminum radiator I see?
 
BugeyeNJ58 said:
Very nice...useful bling. I need to get those steel braided hoses. Is that an aluminum radiator I see?
Click to expand...

Yep.
 

Attachments

  • 22267.jpg
    22267.jpg
    46.1 KB · Views: 202
David, your float bowls are leaning forward as if the wrong grommets were used. The Mini and the inline cars used different intake angles, but with the Mini intake your float bowls would be leaning backwards towards the engine, so thats why I think the wrong gormmets were use, the float bowl should be level, right now your float level is being compromised. We may be able to find the right grommets for them, and level those flaot bowl out, the grommet is what set the float bowl assembly angle, plus I have trick to keep them from being wobbly as well, that we could do as with test other grommets.
 
Hap Waldrop said:
David, your float bowls are leaning forward as if the wrong grommets were used. The Mini and the inline cars used different intake angles, but with the Mini intake your float bowls would be leaning backwards towards the engine, so thats why I think the wrong gormmets were use, the float bowl should be level, right now your float level is being compromised. We may be able to find the right grommets for them, and level those flaot bowl out, the grommet is what set the float bowl assembly angle, plus I have trick to keep them from being wobbly as well, that we could do as with test other grommets.
Click to expand...

I'll bring it by one day soon. I thought the angle looked wonky.
The grommet is real rubbery and the bowls can be moved quite a bit....down right wobbly.
Thanks Hap!
 
If those grommets are offset, you *may* be able to temporarily get the proper bowl angle by just swappin' 'em, side to side. :wink:

...but if they're wobbly, Hap's REAL fix is the best bet.
 
Back
Top