• Hey Guest!
    British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!
    **Upgrade Now**
    (PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Tips
Tips

Howling hood

Share this page

sparkydave

sparkydave

Jedi Knight
Country flag
Offline
I switched from the Zenith to the Weber DGEV, and while it runs well, I have a new problem. My hood is rattling like crazy, especially when decelerating. There's just this overwhelming BLAAAT. I've tried adjusting the rubber bumpers on the hood, but it's acting like a giant sounding board. Only thing I can think of is to check for loose motor mounts, since I had to wrestle with the EGR valve to remove it. Any ideas?
 
Check to see if the air cleaner's hitting the under side of the hood. I had my Weber manifold milled down for clearance on my Bugeye.
 
I just went out and checked for clearance on my DGV and sure enough, its been rubbing under the bonnet. How much did you have milled off your manifold to gain clearance?
 
I don't recall, but I just measured the flange at 5/16th" and the screws hold just fine. I also have a KN filter that measures 1 3/4" in height. The domed one I tried was too tall.
Bill
 
Back
Top