Hi All,
Following my rebuild of the HD6 carbs (thanks for the advice on my previous thread) on my BT7 I have been looking at the float bowl height adjustment. According to my manual the height should be set to 11mm (using a drill bit or similar). At the moment the forks are about 12-13mm. dies this mean that the fuel level will be 1-2mm to high in the jet and that the mixture will me too rich? Should I adjust to exactly 11mmor leave well alone?
Thanks
Phil
Following my rebuild of the HD6 carbs (thanks for the advice on my previous thread) on my BT7 I have been looking at the float bowl height adjustment. According to my manual the height should be set to 11mm (using a drill bit or similar). At the moment the forks are about 12-13mm. dies this mean that the fuel level will be 1-2mm to high in the jet and that the mixture will me too rich? Should I adjust to exactly 11mmor leave well alone?
Thanks
Phil