-
Hey Guest!
British Car Forum has been supporting enthusiasts for over 25 years by providing a great place to share our love for British cars. You can support our efforts by upgrading your membership for less than the dues of most car clubs. There are some perks with a member upgrade!**Upgrade Now**
(PS: Upgraded members don't see this banner, nor will you see the Google ads that appear on the site.)
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
TR2/3/3A how do i fix this hood line?
- Thread starter aaronf30
- Start date
Share this page
Offline
Looks like the spring in the bonnet lift device is doing too good a job. Take the spring holder portion off and see if the line is better. If so, try a slightly softer spring.Bob
CJD
Yoda
Offline
That's not too bad!
Bob is correct. Make sure the spring is assembled preoperly so it isn't pressing abnormally hard against the bonnet, and the rod is hitting in the slot in the bonnet.
The rubber bumper on the right needs to come up just a hair. You may or may not have to add shims to the dzeus bracket so the fastener still latches easily. The left may need to come down a hair...but maybe not...it's hard to tell from one angle view.
Once the bumpers are set, place towels or some other soft material over the bumpers, and then gently press down on the high area just left of center. You want to over-spring the metal so when released it will stay down, even after closing with the spring pressure. It'll take a good bit of pressure, and maybe some "bouncing" to spring it down. It will, no doubt, take several tries to get it level across the front.
Bob is correct. Make sure the spring is assembled preoperly so it isn't pressing abnormally hard against the bonnet, and the rod is hitting in the slot in the bonnet.
The rubber bumper on the right needs to come up just a hair. You may or may not have to add shims to the dzeus bracket so the fastener still latches easily. The left may need to come down a hair...but maybe not...it's hard to tell from one angle view.
Once the bumpers are set, place towels or some other soft material over the bumpers, and then gently press down on the high area just left of center. You want to over-spring the metal so when released it will stay down, even after closing with the spring pressure. It'll take a good bit of pressure, and maybe some "bouncing" to spring it down. It will, no doubt, take several tries to get it level across the front.
