Hey Guest!
Hey - did you know if you click on the title of a thread it will take you to the first unread post since you last visited that thread?
but were afraid to ask: 
STOP!! Never post your email address in open forums. Bots can "harvest" your email! If you must share your email use a Private Message or use the 
smilie in place of the real @
Pretty Please - add it to our Events forum(s) and add to the calendar! >> 
Offline
I bought a new horn relay switch from Moss. Unlike the original one, this one has four, instead of just three, contact points--C1, C2, and W1 on original. The new switch includes a post which would be "W2" and which supposedly goes to ground.
Using the instructions, I connected all original wires to the correct post of the new switch, leaving the fourth (new)contact (W2) empty.
Nothing works. Naturally, there must be another way to connect the wires. Or I have a bad switch, or I'm ignoring something obvious.
Any thoughts or ideas? Thanks.
Using the instructions, I connected all original wires to the correct post of the new switch, leaving the fourth (new)contact (W2) empty.
Nothing works. Naturally, there must be another way to connect the wires. Or I have a bad switch, or I'm ignoring something obvious.
Any thoughts or ideas? Thanks.
